Removing trim tilt units

Post Reply
mike davis
Platinum Member
Platinum Member
Posts: 147
Joined: Sun Jan 24, 2010 2:58 pm
Location: kununurra,wa
Contact:

Removing trim tilt units

Post by mike davis »

Have got a 2011 honda 40hp four stroke and am trying to remove the trim tilt unit to put new seals in the ram. Have removed all pins and bolts but is still unable to remove from lower bolt section, is there a secondary bush in there and how do I remove it. The trim unit is a showa brand. Any suggestions appreciated.


Nika
Seadog
Seadog
Posts: 223
Joined: Mon Nov 15, 2010 8:37 pm
Location: Humpty doo

Re: Removing trim tilt units

Post by Nika »

You need to loosen the large pin at the to where the motor tilts from then take either the left or right set of bolts out (2ea) that hold the outboard to the transom, this will allow the trim unit to be removed.
Nick
4WD, boats, beer, is there a theme here?
Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “Boats, Motors, Vehicles & Trailers”