Hard to say - reinstalled external puck, did software upgrade, adjusted settings (similar to your last post) all at once.balou wrote:Slug did this upgrade improve your lag issue?
Balou,,I was having a few issues with mine ,such as loosing the image when reversing and the lag time was very slow,I,ve used this upgrade and noticed a big improvement.I still loose the image if I go hard in reverse,but the refesh time is only a couple of seconds . Cursor lag could still be better.Remember when I showed you how I use the compass ,,,,by using this method and sonar I don,t rely on the plotter as much.
Might need a refresher mate, too many beers that trip. Let me know when you need a decks againjeffish wrote:Balou,,I was having a few issues with mine ,such as loosing the image when reversing and the lag time was very slow,I,ve used this upgrade and noticed a big improvement.I still loose the image if I go hard in reverse,but the refesh time is only a couple of seconds . Cursor lag could still be better.Remember when I showed you how I use the compass ,,,,by using this method and sonar I don,t rely on the plotter as much.
Cheers
balou wrote:Found this on net on how to improve curser refresh...
This may have been mentioned earlier but you can also increase the refresh rate of your internal receiver by following the steps below.
1) Press “Page” button
2) Press the right arrow on the cursor pad to scroll over to “Waypoints, Routes and Trails”
3) Use the arrows to select “trails” and hit the “menu” button.
4) Use the cursor pad to highlight settings, then press the enter button
5) Change the “logging type” to “Time”
6) Finally, set the time to “1 sec”. Press close and exit out.