North Australian FISH FINDER TM forums

Hey guys

any tips on trailer wiring......?
have dunbier 7 pin plug got pulled not many wires left to follow.
Have two sets comming back same colors each side ,B,Y,R,G,W.......
MUST have to join different colurs together or somthing...not working following the diagram on pkt .

any help welcome

Try this link. http://www.narva.com.au/products/browse/wiring-diagrams

Yeah cheers mate
But there are two yellows two greens only need one for each light
when i wire thetogether and terminate only indicators work no brake lihgts must have used extra wires for somthinelse ?
brakes revrse parkers side lights earth , brakes and indicotrs comm on when indcator wire hooked up?
but when put foot on brkes nada.................must be some earth problem.

thanks mate..........

Not explaining real well but i have 5 wires each side comming to the front.....10 wires at junction .

Whats coming out the back of the lights? Might pay to start from the back end and work your way to the front.

Is it a voyager trailer by any chance? I have the same and i just fluked it. . but no side/clearance lights since i re-wired mine, no matter what i tried.

Sounds like they have run 2 cables back to the front rather than splitting one. My guess is
2 red wires together to no. 6 for brakes.
2 brown wires together to no. 7 for tail lights
1 yellow wire from LHS to no.1 for left indicator
1 green wire from RHS to no.4 for right indicator
2 white wires together to no. 3 for earth.
The rest do nothing.

I think that's how it would go. If you see smoke its wrong. The Narva link above sets it out. Be wary of shorts in the cables, dodgy previous work and I have also had a LED that was wired wrong from the factory. A bit of liquid electrical on connectors makes them last a lot longer.

Thanks guys tried the standard wiring just get different combinations.

sat down with 12 v0lt battery tested them one at a time stillhave brake light indicators both come on at same time?
must be a short.................might go back to a light board again less dramas.


Cheers


any body got a good design for a home made job?

made one years ago that folded in half to save room.

Poor earth / chassis contacts causes Christmas tree effects. Make sure you double check earth/ normally black wire integrity. Wire colors can be different but green by standard is right indicator, yellow is left, red is stop, white are ?". Dang can't recall right now but that probs points to poor chassis earth, more likely from the output harness of the vehicle itself.
It is not a short circuit, a short will blow your fuse or fuses related to the circuits. Earth wires , don't,get shorted, they'll just create bad power loops.
Btw, double checking earthed points, means derusting, retighting screws and bolts related to that earth point .

Put in new lights got every thing but parkers going.

Thanks for the advice and insights Cheers

Should have just rang me mate. If you can't work out Parker's let me know
Btw plate size white is earth.

yeah mate would have saved some time just did not think of it.

Hey did you hear about that Job?

fff1964 wrote:Put in new lights got every thing but parkers going.

Thanks for the advice and insights Cheers

chek the fuse for your tail lights on the car, my triton has a separate fuse for the tail light under the bonnet, its in a few cars for some reason, same thing happened to me , no trailer tail lights/ parkers, and that was the problem, your car tail lights will work but not your trailer..

Yeah- I had the same problem- tail lights but no indicators- found a blown fuse under the bonnet marked trailer- there's one under the dash too

Nah mate haven't heard anything. Did you get the vitara all sorted out?